NANDO Eagle PCB (48pin ZIF) about nand_programmer

[kooroshi60]

And here is a picture of the completed Nando programmer. Many thanks to Mr. Bogush

h

[ucsoom]

I created a programmer like yours based on your PCB file. The trouble now is that I have searched the internet for a suitable hex file for this programmer. Could you please send the hex file of your programmer? My email address is [email protected]

[kooroshi60]

I was wondering if it is possible to use the STM32f103VET6 instead of VCT6?
VET6 is a bit more expensive; but what if some one has it available?!
Based on the datasheet, the only difference is the flash memory size.
Actually I had done this before on a STM32 development board and it works.

[bbogush]

Thanks for sharing ZIF schematic.
VET6 and VDT6 should also work, the redundant memory will not be used.

[bbogush]

Very nice PCB. Thank you!

[ucsoom]

[bbogush]

@ucsoom all hex files are located on Google driver https://drive.google.com/drive/folders/1AGWV5_WANd6tItfXJFq4AlQePkRsusNU

[ucsoom]

The website you sent cannot be accessed

[whitcloudfly]

可以用STM32cubeide开发hal库的固件，移植难度很小。