v0.0.7 doesn't fix the no response about hkcam

[brutella]

@baseship v0.0.8, which includes the fix, will be released tomorrow.

[brutella]

Sorry that v0.0.7 doesn't fully resolve this issue.
I think this issue only happens when the iOS devices connects with an IPv6 address.
Still investigating…

[brutella]

Fingers crossed that 488f2c7 fixes this issue.

Would be great if somebody could verify that by compiling and updating the hkcam binary.
https://github.com/brutella/hkcam/wiki/How-To-Update#update-from-source

[RaymondMouthaan]

@brutella, just build, installed and started 488f2c7, fingers crossed it works 👍

[brutella]

Please everybody update to 3a825f0

[brutella]

Does it work now for everybody with the changes in 3a825f0?

[RaymondMouthaan]

@brutella, running 3a825f0 for two days now and it works!

[RaymondMouthaan]

Did you remove the camera first and re-added it?

[RaymondMouthaan]

@brutella, I will... However I am running 0.0.7 from this morning and until now it still works. Any idea how to reproduce the issue faster?

[brutella]

@RaymondMouthaan This issue only seems to affects incoming IPv6 connections. Maybe you can reproduce the issue when you are on an IPv6 only WiFi network.

[RaymondMouthaan]

@RaymondMouthaan This issue only seems to affects incoming IPv6 connections. Maybe you can reproduce the issue when you are on an IPv6 only WiFi network.

as far as I know I don't have an IPv6 network, so I guess we have to be patience until it occurs or even better if it will not :-)

[dfbills]

I'm on a IPv6 network and cannot connect after updating to 0.0.7 on both Mac and PI.

[brutella]

@dfbills Could you please try the above mentioned fix?

[dfbills]

I compiled 3a825f0, ran on the PI, and was able to successfully add to HomeKit. Running on the Mac build is still not working and does not show up in "Add Accessory."

Log shows:

Warlock:hkcam dfbills$ make run
go run cmd/hkcam/main.go
DEBUG 2019/06/01 13:59:42 camera_control.go:153: add: 3102379.jpg
DEBUG 2019/06/01 13:59:42 camera_control.go:194: {"assets":[{"id":"3102379.jpg","date":"2019-05-06T17:46:18-04:00"}]}
INFO 2019/06/01 13:59:42 ip_transport.go:186: Listening on port 61758

No additional info appears after many minutes.

[brutella]

You don't have to add the camera again to HomeKit if you just replaced the binary.

If you want that the camera appears as a new device, you have to delete the contents of the folder /var/lib/hkcam/data.

[dfbills]

@brutella - Thanks! For those following this thread, on the Mac, this is the data contents of the "Camera" folder at the root level of the hkcam project.

I finally have both Mac and Pi versions up and streaming again.

[baseship]

The changes now work. Thanks. Is the Raspian Image also fixed?

[brutella]

Should be fixed in v0.0.8