cristianvarg11 Goto Github PK

awesome-startpage

This is a carefully compiled list of remarkable projects with the focus on startpages.

esp32-school

This project use the target esp32 with a Python app for mqtt, in this sense, has a schedule and periferics (RTC, PIR, DHT11 and Leds)

i3-config

My configuration for i3

kanji

🗻 A minimal startpage for the browser.

nvim

My configuration for neovim.

nvim-lua-config

Configuration for neovim with lua

pwm-adc

in this project, is used MicroPython on ESP32 target to config Pulse width modulation in function of the ADC

raspberry-office

in this program it's used a Raspberry pi model 3B+. From module datetime of python and gpiozero of Raspberry is generate an automatic signal for illumination of offices, using the GPIOs 18, 23, 24 for a RGB Led for indicate the proximity of events, 10 for a buzzer and 15 for indicate a state of illumination of the office.the office only work the five days of the week(Mon - Fri) in the interval the 7am at 6pm, any value out of this ranges (days or hours) the office is close.

raspberry_sensors_and_rtc

In this project it's used the Raspberry Pi 3 model B+, the project function is: 1. capture the system date and time to synchronize the RTC DS3231, the system must be able to detect synchronization failures between the system and the device so that if There is a difference of more than two seconds between the system time and the RTC time. automatically proceed to synchronize the RTC3231. 2. Connect the motion sensor and activate it by a time window of 2 minutes, record the activation of the PIR sensor in a text document, with the detail of the date and time the detection occurred. 3. Every time the motion sensor is activated, an alarm must be activated using a Buzzer on and off with a duration of three seconds. 4. Connect the humidity and temperature sensor, every 10 seconds record in another Document the current measurement value of the device, incorporating identifiers that allow to recognize reading failures. In this sense, the PINs used are: *RTC -> Pins: 1, 3, 5, 7, 9 for 3.3V, SDA, SCL, NC, and Ground respective *DHT11 -> Pin: 19 for data *PIR -> Pin: 40 for level *Buzzer(alarm) -> Pin: 36 for level

react-redux-introduction

rick-and-morty-cristian-app

An simple application that use the rick and morty API. Made in NextJs

spicetify-cli

Commandline tool to customize Spotify client. Supports Windows, MacOS and Linux.

sway-config

My sway configuration

thingsboard

Open-source IoT Platform - Device management, data collection, processing and visualization.