Default paths / configuration. about pyopencv

[GoogleCodeExporter]

Thanks, Michael. I'll see what I can do to avoid using config.py.

Cheers,
Minh-Tri

Original comment by [email protected] on 6 May 2010 at 9:00

• Changed state: Accepted

[GoogleCodeExporter]

Starting from r1025, PyOpenCV can be build via CMake (thanks Dat) as well as 
via setuptools. bjam is no longer required. File 'config.py' is still needed 
but it is automatically created via CMake. If you have time, please feel free 
to try it out on your platform and let me know if there is any problem. 

To install PyOpenCV via CMake:
mkdir build
cd build
cmake ..
make
make install

To install PyOpenCV via setuptools (PyOpenCV will automatically invoke CMake to 
self-configure if the file 'config.py' is not found):
python setup.py install 

For now, I'd like to close this issue. Please don't hesitate to open a new 
issue if the problem persists. Thank you very much for your feedback.

Best regards,
Minh-Tri

Original comment by [email protected] on 27 Aug 2010 at 7:55

• Changed state: Fixed