Failing to get any analog input on Arduino Due about gobot

[zankich]

@golangdaddy The correct pin number for firmata analog pins is pin "0" for the pin labaled "A0" on the board.

I have never tested firmata on the Arduino Due, so it's likely there is an issue with our firmata implementation or the Due's firmata compatibility. According to the Firmata wiki, the Due supports firmata version v2.3.6, so if you could double check your version to make sure you're running a compatible version.

Are you sure your circuit is configured correctly? The Due io supports a maximum of 3.3v, unlike the higher voltage of the uno. Do you have an arduino sketch you can test it with, just so can isolate that it's a Gobot issue?

[golangdaddy]

Thanks for your reply. I tried checking with a sketch but it's not gobot so I dont know how to tell whether it's working because I have no feedback on the Arduino IDE telling me whether input is triggered. It didn't work but that's not conclusive enough, I will have to play around, I tried loading other firmata versions but they all panic with the code I was using.

I might just have to order a UNO asap.. I'm very sure I should have got some input events triggered with all of the circuits i built, ports and combinations i tried.

Thanks again

[zankich]

@golangdaddy If you purchase an uno, then Gobot will definitely work with no issues. RadioShack sells them, so if you have one near your house you can pick one up lickety split!

[golangdaddy]

Thanks have ordered one. Should have properly read the gobot page. I'm sure
the Due will be usable in the future however.

On 2 October 2014 02:52, Adrian Zankich [email protected] wrote:

@golangdaddy https://github.com/golangdaddy If you purchase an uno,
then Gobot will definitely work with no issues. RadioShack sells them, so
if you have one near your house you can pick one up lickety split!

—
Reply to this email directly or view it on GitHub
#116 (comment).

[deadprogram]

Anything ever happen with this?

[solojavier]

Please reopen if there is still an issue....