install error about crtm

[BenjaminTJohnson]

Do you know which version you're using?

You can find CRTM_Version.inc

And look at the contents.

The readme file that comes with the installation gives step-by-step instructions on how to build. It sounds like one of the steps was missed perhaps?

It's looking for make.rules to be present, and it's not finding it. You might try copying the make.rules file into the location it's asking for, but I recommend following the build steps first.

[fipoucat]

I am looking for 2.4.0 but on github it is confusing for me on which file to download? I haven't seen a full tar.gz file. I used the master file from github but always when running makes the systems look for files it cannot find.

…

On Tue, May 3, 2022 at 9:05 PM Benjamin Johnson ***@***.***> wrote: Do you know which version you're using? You can find CRTM_Version.inc And look at the contents. The readme file that comes with the installation gives step-by-step instructions on how to build. It sounds like one of the steps was missed perhaps? It's looking for make.rules to be present, and it's not finding it. You might try copying the make.rules file into the location it's asking for, but I recommend following the build steps first. — Reply to this email directly, view it on GitHub <#24 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AAXY6LI3RS5C4ORV2DTHZNDVIGIJ3ANCNFSM5VABIBIA> . You are receiving this because you authored the thread.Message ID: ***@***.***>

[BenjaminTJohnson]

git clone https://github.com/jcsda/crtm --branch=release/REL-2.4.0_emc 

for the EMC-focused branch. If you're going to use CRTM within a model, such as GSI / WRF, this is probably what you need.

[fipoucat]

Thank you, Benjamin, this one works.

…

On Wed, May 4, 2022 at 6:49 PM Benjamin Johnson ***@***.***> wrote: git clone https://github.com/jcsda/crtm --branch=release/REL-2.4.0_emc for the EMC-focused branch. If you're going to use CRTM within a model, such as GSI / WRF, this is probably what you need. — Reply to this email directly, view it on GitHub <#24 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AAXY6LPGCWLUY4ICMOP5ATLVILBCNANCNFSM5VABIBIA> . You are receiving this because you authored the thread.Message ID: ***@***.***>

[StegmannJCSDA]

Closing as resolved.