Code 39 - Scanner unable to decode dashes embedded within the barcode about nbarcodes

[GoogleCodeExporter]

Hello Ken,

Thanks for bringing up this issue. I'll take a look at it soon.

Regards,
Jordão

Original comment by [email protected] on 27 Jul 2013 at 2:37

[GoogleCodeExporter]

Hello Ken,

Can you please try to set the barcode settings as follows:

        NarrowWidth = 1.5f
        WideWidth = 3.5f

It seems I picked the wrong defaults for those values. Please tell me if that 
fixes the issue. If so, I'll later change the defaults to these values.

Regards,
Rodrigo Jordão

Original comment by [email protected] on 27 Jul 2013 at 3:16

[GoogleCodeExporter]

Will do. Thanks, Jord�o.

Ken

Original comment by [email protected] on 27 Jul 2013 at 6:14

[GoogleCodeExporter]

Hi Rodrigo,

Sorry to report to you that the scanner still cannot decode the barcode
with dashes after changing the settings. However the same id number used
for generating barcode through this free online tool works fine.

http://www.barcode-generator.org/

Any suggestions?

Thank you!
Ken

Original comment by [email protected] on 1 Aug 2013 at 6:08

[GoogleCodeExporter]

Hello Ken,

The only difference that I see from the generated barcode to the online 
generator you linked to is the height, which should not interfere in the 
reading. But anyway, you can try it:

    BarHeight = 100f
    NarrowWidth = 1.5f
    WideWidth = 3.5f

Apart from that, the only way I could reproduce your issue is to know which 
scanner you're using. If you could reproduce the issue with an online scanner, 
or a phone software scanner, it would be best.

Regards,
Rodrigo Jordao

Original comment by [email protected] on 1 Aug 2013 at 10:43

[GoogleCodeExporter]

Hello Jordão,

Is there a way to set the DPI resolution in nbarcodes? It is set to 72 but
we need to print at 300DPI...Can you please give some suggestions??

Original comment by [email protected] on 21 Jul 2014 at 3:21

[GoogleCodeExporter]

Hello, NBarCodes 2.0 is out. Please be aware that some changes were made to the 
API and to the default values used. Adjustments to your project might be 
needed. Please check if it fixes this issue.

Original comment by [email protected] on 27 Jul 2014 at 11:10

• Changed state: Fixed