Is repeating scanning mode supported for mid360? about livox_ros_driver2

[FPSychotic]

i dont know if that option is for that, but if you change it in the livox viewer2 will work later in ros, the mode will be active until you change it again. obviously would be better a option as the one you said and it works, but it is a
workaround

[leewo0]

@FPSychotic Thanks for your reply. I checked the lidar settings in the livox viewer2. The Scan Pattern had been changed to Repetitive(changing the option worked in the ros driver), but the output point cloud is still non repetitive in both livox viewer2 and ros driver. I noticed the firmware version is 13.17.01.11 and the product info is DevType:Mid-360 FmT in the setting menu. Is this feature not supported by my mid360?

[FPSychotic]

I will check again and check fw version, but quite sure is working

…

On Tue, 4 Apr 2023, 04:10 leewo0, ***@***.***> wrote: @FPSychotic <https://github.com/FPSychotic> Thanks for your reply. I checked the lidar settings in the livox viewer2. The Scan Pattern had been changed to Repetitive(changing the option worked in the ros driver), but the output point cloud is still non repetitive in both livox viewer2 and ros driver. I noticed the firmware version is 13.17.01.11 and the product info is DevType:Mid-360 FmT in the setting menu. Is this feature not supported by my mid360? — Reply to this email directly, view it on GitHub <#36 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AITQOVE74XYYX5GSXASZSMLW7OGLJANCNFSM6AAAAAAWQXDLYI> . You are receiving this because you were mentioned.Message ID: ***@***.***>

[leewo0]

@FPSychotic That's a little werid. Today, I contacted DJI's after-sales staff(my mid360 was bought there), and he learned from the developer of Livox that mid360 does not currently support repeat scanning mode.
Later, they sent me an email which confirms repeat scanning mode is supported.

[FPSychotic]

Need check but I read about it has one LoL

…

On Tue, 4 Apr 2023, 13:04 leewo0, ***@***.***> wrote: @FPSychotic <https://github.com/FPSychotic> That's a little werid. Today, I contacted DJI's after-sales staff(my mid360 was bought there), and he learned from the developer of Livox that mid360 does not currently support repeat scanning mode. — Reply to this email directly, view it on GitHub <#36 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AITQOVAJQLZGTVPYMQC6KSDW7QE5XANCNFSM6AAAAAAWQXDLYI> . You are receiving this because you were mentioned.Message ID: ***@***.***>

[leewo0]

not supported yet

[FPSychotic]

In that case the livox brochure and specs are wrong as it said it has repetitive mode

[LotfiZ]

Hi Livox team,

Are you planning to support Repetitive pattern for the mid 360 ? If yes, can we have a timeline estimation if its possible ?

Thank you