Solid phase is overwritten - geometrical limitations of inlet? about lbpm

[JamesEMcClure]

LBPM always assigns the inlet / outlet in the z-direction if you are using an external boundary condition. These
are usually BC=3 or BC=4 for lbpm_color_simulator. This is done so that each region is a contiguous memory region. If you drive the flow in the z direction, then you should be able to run this geometry without overwriting the solid layer.

You could also drive the flow with an external body force by setting BC=0 in which case you can drive the fluids in either the x, y or z directions.

See this link for BC keywords for the color simulator

https://github.com/OPM/LBPM/blob/master/docs/source/userGuide/models/color/index.rst

[to3sk]

My flow was in the z direction.
Thank you for the answer.