Can we use MQ-131 module with 4 pins with the library? (instead of raw sensor with 6 pins) about arduino-mq131-driver

[ostaquet]

1. The sensors have always 6 pins but only 4 are really used. I don't have the documentation of your module. So, it is difficult to know the parameters of the breakout module. Do you have some doc?

2. The result of the sensor is a resistance ratio. The resistance ratio is computed based on the sensitivity curves of the sensor as defined in the datasheet. The formula are in the Excel sheet (https://github.com/ostaquet/Arduino-MQ131-driver/blob/master/extras/datasheet/Sensitivity_curves.xlsx).

[damico]

I believe that lailomah is talking about this board:

Which can be understood by this circuit diagram:

Where the R2 is 1KOhm.

Best Regards,

Jose Damico