YubiSwitch not disabling Yubikey nano on macOS 12.6 about yubiswitch

[davidrothera]

Yes the instructions need updating along with fixing the updating of the helper.

Thanks for the confirmation its working again.

[davidrothera]

Did you have a version older than 0.14 or 0.15 installed prior perhaps? I have a feeling the helper tool isn't being updated with the new version which is now signed with a different certificate for communication authentication.

I'll try and reproduce this today. can you try and follow the uninstall instructions on the README to fully remove the helper and then install 0.15 fresh.

[jin-ds]

Hi David,

I had indeed an older version recently, so that could be it!

I followed the uninstall steps, but the issue remains.

One thing I noticed is that it remembered my config, so is it possible there is some caching happening?

[davidrothera]

Did it ask you for an admin password upon startup for installing the helper?

[jin-ds]

No, it did not. I remember doing it before, but not with the upgrade, so it could be the helper!

[davidrothera]

After following the instructions there should be no helper present at the end. If you run ls /Library/PrivilegedHelperTools/com.pallotron.yubiswitch.helper does it show no file found?

The helper is installed/blessed upon startup so once removed and then re-run it should ask for admin password to install the helper.

Your settings are stored in a different place and are not removed as part of the uninstall process and so your settings being preserved is somewhat expected.

[jin-ds]

So, I uninstalled once more, but it seems the rm command needed to be sudo rm and rm -rf to remove the application.

I then reinstalled, readded accssibility, and that did the trick. It's working again, thanks!

Perhaps those instructions could be added in the readme?

Thanks for the help on this!