dev2: Homing causes motion on E axis (extruder) about repetier-firmware

[repetier]

Sorry, but I do not really understand what you are trying to say. You mean after G92 E2 a new homing will move extruder these 2mm?

[kyrreaa]

Yes, or retracts, at high speed.

[repetier]

Sorry for the long delay, was quite busy.

I have checked it. I could not reproduce the retract problem, but a saw that E offset does not get reset. I fixed that now hoping it helps.

E gets reset if G28 has no parameter or contains E0. It is set with priority 0 so if the problem happens already on X homing you need to set x home priority to 1 at least.

Hope it works now, otherwise please tell me very exact which of the many homing moves does the retract. I have no core xy so if there is something special that might explain it, also it just runs the same simple home commands and xyz mapping does not include e so I expect no difference.