Second value during initial adjustment about midi2lr

[lovelacecreativeco]

Have you tried 'Enable Pickup Mode' ?

[darthdurden]

I've seen similar behavior. It always seems to occur when I switch layers on my X-Touch Mini. The software seems to not be quite syncing the current lightroom values with the current midi values. For instance if I double-press the A button to switch to the layer, all of the lights go to 0 instead of the selected values.

I've tried turning off pickup mode and it works better in some respects, but it also works a lot worse in others so its not viable.

I can pretty reliably reproduce this by switching through layers, though I can't determine what the exact triggering pattern is.

I've also noticed that if I switch to layer B, the lights on my dials don't correspend with the selected dials at all (they are just off) unless I start turning them.

[wunditta]

This is definitely the pickup mode, when enabled this is it's intended behavior. When a slider value and the value in Lr do not match, and for some reason the value on the MIDI device cannot be set to the current Lr value, the plugin waits (movement has no effect) until the slider value (first value shown) reaches the Lr value (second value shown).

You can disable pickup mode in the application settings, then the Lr value is always set to the MIDI control. But I cannot say which is better.

I do have the X-Touch Compact and cannot reproduce this issue. Neither with the motorized sliders, nor with the dial knobs, nor by switching layers. Whatever I do, the Compact gets updated with the correct values. When I switch to layer B the LEDs on the dial change of course, going back to A sets them to the value before and I can continue changing the parameter normally.

Is this still an issue, by the way? Maybe it is something with the Mini and there is a new firmware?

[rsjaffe]

Fixed in 4605af1