Properties window: Test Target SWF mode setting a little flakey about flexmonkey

[GoogleCodeExporter]

This issue still occurs in RC1... on my setup, I did an upgrade over beta 2.  
My 
previously set-up project is using monkeylink.  When I go to the properties, 
the 3rd 
option is selected.  Click on agent and the view does not update.  Click 
cancel, 
then go to properties again.  MonkeyLink is selected still; click on Target SWF 
and 
view state does not update also.

I also found that switching from MonkeyLink to Target SWF also does not update. 

After a lot of clicking around, it seems to get into a situation where clicking 
on 
agent will update the view, but not when clicking on Target SWF (both from when 
ML 
is selected)...

Original comment by [email protected] on 21 Nov 2009 at 12:16

[GoogleCodeExporter]

Sorry, you are correct.  The fix did not make it into the release, but will be 
in the next.

Original comment by [email protected] on 21 Nov 2009 at 12:37