Self Maded Card 100% Page Failed about pcileech

[ufrisk]

I don't know. The ScreamerM2 code should be working if it's compatible on the FPGA PIN level. It looks like its 100% fail though in your screenshots.

If you wish you could send one my way and I could take a look at it, maybe it's something obvious, maybe its not.

[ufrisk]

Also it would be a interesting for my project to support an M2 device again... The ScreamerM2 have been out of sale for quite a long time now.

[ITANGTANGI]

Hi, thanks very much for your help, I tested it on my linux system and seems it works fine as Figure, and i'll take a more detailed tests then optimiz my hardware. It's glad to ship a board to you for offical support after optimization , you can contact me if you want : )

[ufrisk]

Nice, I'm looking forward to take a look when its ready. It looks very nice, the on/off switch as well :)

By then I might have an upgrade of PCILeech to use the full PCIe x4 interface as well, but sadly it won't be any faster since the bottleneck is the USB.

[ITANGTANGI]

Ha ha, I have completed this and made it open source ! You can check it at https://github.com/ITANGTANGI/a7_tang_m2_usb . BTW, now you can contact me with [email protected] and give me you address and i will ship you one : ) ; In the feature, it's interesting to use ktintex ultrascale chip 12.3Gbps GTX and XillyUSB (https://xillybus.com/) make a 10Gbps USB3.0 without USB-PHY for a faster connection with host.

[ITANGTANGI]

I'm sorry I made a mistake, XillyUSB only supports USB 3.0 up to 5Gbps