Set wwactive doesn't work about irt-esp

[Victor-Mo]

The 'boiler wwactive on' and 'boiler wwactive off' should switch the tap water on and off. It does seem to correctly set it on the boiler, but it is not reported in the status (info command). I will have a look, because something is wrong.

[Victor-Mo]

@mafradon I have checked the tap water setting. The telnet command is 'boiler wwactive on/off'. The MQTT topic is 'boiler_cmd_wwactivated' (for example: 'home/irt-esp/boiler_cmd_wwactivated') a value of 0/1 will switch it on and off.

The problem was reporting the tap water status. The 0x05 message was implemented, but it was not processed/called. I have fixed that. Just keep in mind it can take a minute before the status is reported. So if you switch the tap water it can take a minute before showing up. It is currently building a new firmware. As added bonus this version also reports the outdoor temperature (if you have an outdoor sensor).

[Victor-Mo]

Closing the issue because I think it is fixed, if not veel free to reopen.