ST-LinkV2 nRESET pin about cmsis-dap

[x893]

Hello,
I have various version of dongle - so may be make a mistake.
I'll review and fix

Thanks
David

[siorpaes]

All right, thanks! let me know if you need any further information, esp on the dongle's hardware

[x893]

I check ST-Link V2 schematic (from NUCLEO board) and see PB0 for T_NRST signal. PB6 used for SWM_RST (for SWIM protocol)

[siorpaes]

Yes, you are correct: the schematic of Nucleo and Discovery boards do have NRST routed to PB0. However, the RST signal of the ST-LinkV2 dongle I have is connected to PB6. I triple checked continuity with multimeter. Could you verify on yours ?

[x893]

I havn't V2 version but you can make new configuration STLINKV2 and make changes for nRST. Later send pull request. I can do this myself but later. :)