Can't connect to wwan0: Device class NMDeviceGeneric had no complete_connection method about xmm7360-pci

[tgxn]

I have just merged NetworkManager support #66 so this may resolve your issues accessing it.
Otherwise, there was previously no support for nmcli, so this would have only just started working.

Given you are both getting IP Addresses from the modem connection, this would indicate you might have a related problems such as:

• WiFI Connection may need to be disabled
• You may need to remove/use the telco-provided DNS servers.
• You may need to check that no conflicting routes are present.

[tgxn]

I'm going to close this issue, if you do continue to have issues, could I ask that you try the new dbus functionality, and create a new issues if this is still causing issues.

[carefreecaribou]

I have this same issue! When I start this tool, I seem to get a working network interface. It even grabs the IP address it is supposed to according to the DNS scheme; however I cannot connect to it! I see that the connection is described here as up, but I cannot send data through it.

wwan0: flags=4305<UP,POINTOPOINT,RUNNING,NOARP,MULTICAST> mtu 1500 inet 35.24.195.115 netmask 0.0.0.0 destination 35.24.195.115 inet6 fe80::f275:ee3b:c85f:11e1 prefixlen 64 scopeid 0x20<link> inet6 ::fcdb:20ee:7c52:dd7 prefixlen 64 scopeid 0x0<global> unspec 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00 txqueuelen 1000 (UNSPEC) RX packets 0 bytes 0 (0.0 B) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 0 bytes 0 (0.0 B) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
NMCLI Shows:
wwan0: unmanaged "Intel XMM7360 Advanced" unknown (xmm7360), hw, mtu 1500
I also have an X1 Carbon 6th Gen.dns