deleted about ioio

[ytai]

Is your IOIO running the correct firmware (V3.03 bootloader / V3.23 app)?
I'm using the exact same setup (Nexus S, ICS) and running wireless ADB
while working with the IOIO without problems. Is it possible that the Wifi
connection is flaky?

As a side-note: you may find working with IOIO over Bluetooth while having
your phone connected to the PC a convenient alternative. Once your app is
ready, you can run it using OpenAccessory or ADB.

On Thu, Apr 26, 2012 at 12:54 AM, HerrHofrat <
[email protected]

wrote:

Hello,

I've got a problem when I want to debug my app over wireless ADB. When I
connect the IOIO and the Wireless ADB is running, ADB seems to get closed.
When I run adb devices in the shell, no devices are attached. When I
restart the wireless adb on my phone, I can start debugging, but then the
IOIO is not recognized by the app.
I also tried start debugging without IOIO connected, but as soon as I
connect the IOIO the debugging sessin gets closed.

I'm using the Hello Ioio App with the IOIO connected as an Open Accessory.
My phone is a Nexus S running Android 4.0.4!
Sometimes debugging is working, but only 1 in 10 times. Is there anything
I am doing wrong?

Regards from Austria!
Roman

---

Reply to this email directly or view it on GitHub:
#24

[HerrHofrat]

Ok , that might be the problem - my Bootloader is IOIO0300.. Need to
get an programmer and than I will try it again!

Thank you!

2012/4/26 Ytai Ben-Tsvi
[email protected]:

Is your IOIO running the correct firmware (V3.03 bootloader / V3.23 app)?
I'm using the exact same setup (Nexus S, ICS) and running wireless ADB
while working with the IOIO without problems. Is it possible that the Wifi
connection is flaky?

As a side-note: you may find working with IOIO over Bluetooth while having
your phone connected to the PC a convenient alternative. Once your app is
ready, you can run it using OpenAccessory or ADB.

On Thu, Apr 26, 2012 at 12:54 AM, HerrHofrat <
[email protected]

wrote:

Hello,

I've got a problem when I want to debug my app over wireless ADB. When I
connect the IOIO and the Wireless ADB is running, ADB seems to get closed.
When I run adb devices in the shell, no devices are attached. When I
restart the wireless adb on my phone, I can start debugging, but then the
IOIO is not recognized by the app.
I also tried start debugging without IOIO connected, but as soon as I
connect the IOIO the debugging sessin gets closed.

I'm using the Hello Ioio App with the IOIO connected as an Open Accessory.
My phone is a Nexus S running Android 4.0.4!
Sometimes debugging is working, but only 1 in 10 times. Is there anything
I am doing wrong?

Regards from Austria!
Roman

---

Reply to this email directly or view it on GitHub:
#24

---

Reply to this email directly or view it on GitHub:
#24 (comment)