Motion detection does not work when Janus is enabled (v1.37.50 ) about zoneminder

[IgorA100]

Strange, it worked on some of the cameras.
I will study more thoroughly.

ADD:
In RTSP2Web Type WebRTC = WebRTC mode, none of my cameras write.
When RTSP2Web Type WebRTC = HLS mode, two cameras (Beward SV3217RZ2 & Proxiscctv 3516D) do not write at all
Third camera (Dahua DH-IPC-HFW2841TP-ZAS) sometimes! tries to record something, but this does not at all coincide with the events of record length 1-5 seconds with "Minimum section length = 10" & EVENT_CLOSE_MODE = idle
I'm researching further.

ADD:
I received another camera for testing: Dahua HFW5442EP-ZE, and it seems to work fine with RTSP2Web Type WebRTC = WebRTC.
I'm confused.

[IgorA100]

It seems there is still a dependency on Decoding in Source.
If the value is set to = Always, then it works.
If set to = On Demand, it does not work.
Yesterday, when adding a new camera, the default became Decoding = Always, so I was confused, because... didn't pay attention to it.

[IgorA100]

I'm closing it for now, because... Janus is not at fault here.
Motion detection does not work when "Decoding = On Demand" and ONVIF is disabled, which in principle seems to be logical.