QuackWorks is an OpenSCAD project centered around parametric functional prints.
There are currently two publicly released collections:
- Underware - Infinite Cable Management (https://makerworld.com/en/models/783010)
- BJD's Multiconnect Part Generators (https://makerworld.com/en/models/582260) Web version is available here:
- Backer Standards
- Back types as a single module accepting height and width parameters
- All customizable parameters for a back type must be enclosed in their own parameter section
- Positioning Standards
- Model starts at X 0 and goes positive
- Back starts at X 0 and goes negative
- Center the entire unit on x axis last
- Testing Critiera
- Compiles without error
- Test items under 5mm in height, depth, and width and verify back generates properly
- Test for very large items
We use BOSL2 as a dependency and needs to be install accordingly.
If you have nix installed with flakes activated, then everything will be setup for you with nix develop.
Shield:
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
