bramkn / n8n-nodes-run-node-with-credentials

n8n-nodes-run-node-with-credentials-x

The node allows you to dynamically set the credentials to be used for a specific node you want to run. With this you have to paste in a node you want to use, this can be any node with any parameters set. By then also entering the credentials ID the node is ran with those credentials.

Warning You can only use the same type of credentials as the original one set in the node that is pasted in. Be sure to enter credentials, so the node know which credentials need to be replaced. Without credentials set, the node cannot determine the credentialtype name and therefore cannot set it.

Developer

Hi,

My name is Bram and I am the developer of this node. I am an independant consultant and expert partner of n8n. My nodes are free to use for everyone, but please consider donating when you use my nodes. This helps me to build and maintain nodes for everyone to use.

If you are looking for some outside help with n8n, I can of course also offer my services.

• Node Development
• Workflow Development
• Mentoring
• Support

Please contact me @ [email protected] if you want to make use of my services.

For questions or issues with nodes, please open an issue on Github.

n8n-nodes-run-node-with-credentials's Issues

Node installed but cannot find it when want to add it

Hi Bram,

I am a low code beginner.
I just installed the node using npm i n8n-nodes-run-node-with-credentials-x but cannot find it when I want to add the node in one of my workflows.
Here a capture of the installation. Perhaps it didn't work well ?

Thank you very much for your work !

Jeremy

Can't install from n8n (Version 1.47.3)

I see this error message:

Error installing new package
Error loading package "n8n-nodes-run-node-with-credentials-x" :The specified package could not be loaded Cause: Cannot find module '/home/node/.n8n/nodes/node_modules/n8n-workflow/dist/index.js'