bramoosterhuis / com.devolo-legacy Goto Github PK

Requesting support for Room Sensor DRS21 MT:2649 -- currently only supported by raw Z-wave connection to be switched on/off -- reading temperature, receiving temparature inc/dec request would be required
Requesting support for Metering and Switching plug MT:2646 -- currently not pairing, must have would be switching functionality, nice to have - consumption measurement

Do you plan to support further devices like the Devolo Motion (3-in-1) Sensor or the Door/Window (3-in-1) or the Smart Plug? I heard those are Philio Sensors with customized chip and firmware.

I managed to use the code from the philio app and change the hardware id to devolo. it works quite good, but sometimes the motion sensor hangs in alarm status, which causes a lot of problems.

EDIT: for me it was important to disable the illumination and temperatur differential report, because the sensor spammed their values to the homey and crashed the z-wave.

I have the same pairing same issue.
SW version 1.02
Devolo scene switch MT2652
Device not usable in Homey at the moment

Hi,

I cannot add a devolo wall switch to my homey. During pairing, the device is found, but then blocks at the 'Multichannel nodes worden opgehaald' stage. The switch becomes useless (only a reset is possible) and the switch is not added to homey. Any idea if this is a bug?