cubeleco / aridacityvcv

VCV Rack plugin

aridacity VCV Rack plugin

Overview of modules

clkDiv

A clock divider or basic sequencer with 16 divisions/steps. Move the seq switch up to enable the sequencer mode. When connected, the in value will be sent to the outputs instead of the clock clk. When rst is high, the internal clock will reset on the next clock high.

bCrush

A bit crusher with bit manipulation. rate in and knob controls the sample rate (horizontal) of the signal; res in and knob, control the amplitude resolution (vertical) of the signal. The bit operators are accumulative and affected by the res input and knob. hold is a sample and hold clock input that will override the sample rate controls.

Clip

A hard clipping limiter with inner push and outer limits limit, and center offsets pos for each. pull zeros the inner limit and clip enables/disables the outer limit.

Build instructions are in the VCV Rack Manual

Licenses

All source code is copyright © 2019 aridacity and licensed under BSD-3-Clause

All panel and component graphics in res/* are copyright © 2019 aridacity and licensed under CC BY-NC 4.0.

aridacityvcv's Issues

Add an option to sent the first beat on all divisions in Clock Divider

I've added the clock divider to my template and have been using it often but I wish that there was an option to send the first beat after a reset to all divisions so that logic, sample and hold, sequencers etc start correctly rather than making a sound/event only after number of divisions.

Wrong timing on first output of clock divider?

Output 1 from the clock divider seems to be divided by 16 when it should be the same rate as the clock.