durken1 / pierce Goto Github PK

I'm almost done with my project and have a question.
I have two issues.
First. When I power on and connect, the left side connects immediately, while the right side either doesn't connect or takes a long time to connect.
Second. When the distance from the transmitter is more than 5cm, it doesn't connect properly.

Additionally, I don't have a Windows PC, so I used brew on my Mac to install openocd and stlink.

Hello, good fellow.
Very interesting project.
Are these samples are completely functional?
Don't you mind if I've try to solder fully wireless one with dongle?
Thanks for your efforts.

I am having a lot of trouble flashing the wireless modules. The instructions in the build guide are quite sparse and seem to make a lot of assumptions. Can you write up a more robust build guide with regards to firmware flashing and wireless module flashing?

Does it make sense for pierce to incorporate the interleaved channel table config from https://github.com/mattdibi/redox-w-firmware/pull/7/files ?

Hey I saw the layout should be compatible with choc V1 sockets. Normally you would solder the socket on the bottom of the key, but in the layout here all pin holes seem to be on the top. Do I understand it correctly that choc V1 sockets and switches would be soldered/attached upside down?

Hello, good fellow.
Can I borrow your attention one more time?
How do you think, is it possible?
Thanks in advance.
20230908.DURKEN1.PIERCE-RECEVIER.00.pdf

This is a cool mechanical keyboard. I followed your guide and assembled it.

But I didn't find a receiver box case, so I created it, and I attached this here
receiver_box_case.zip

Hello, your project is very impressive
I want to ask something about the receiver's firmware
How did you write the firmware for the wireless keyboard with a receiver
I would be very grateful if you could answer