fraunhofer-iis / ogre Goto Github PK

Use of /dev/pps0 as non-root user requieres
sudo chmod a+rw /dev/pps0
after each reboot.

Make this default by udev rule?

ogre_console 1.10.1 sends measurements with "signal_type":"E1B" which is not defined in ogrp schema 1.2 (see below)

"signal_type": {"enum": ["L1CA", "L2CA", "L2P_codeless", "L2CM", "L5I", "L5Q", "E5aI", "P1", "P2", "P5", "E1", "E5", "E6", "E5a", "E5b"]},

Workaround:
Switch off the power, this message appears always.

Maybe a problem with the Message decoder.

No PVT output and no measurements at GPS week roll over.

Workaround
Restart ogre_console

Description

Planned to be availble from january 2016.

Description

OGRE returns immediatly instead of trying to acquire satellites, without an explanation of the problem.

Description

No availble time correction for GPS and no PPS (pulse per second) Synchronization

Description

Single point positioning works

Description

Current configuration supports 60 channels.

observation

nothing works, even no status led

steps to reproduce

• disconnect battery
• press power-on button
• observe problem

problem

It seems like nothing works

• H1: without a battery ogre might not have any power at all

suggestions

• T1-1: try to reproduce with battery connected but one without charge

workaround

Ensure a battery is always connected.

Oh, and BTW: this is only a test ticket ;-)

Description

Planned to be availble in september 2016.

OGRP schema 1.2 defines a message "ggto_parameter", whereas ogre_console 1.10.2 sends "ggto_parameters" messages

The firmware under development already supports the LTE-Modul Huawei K5150 and the Telit GC864-QUAD V2 (2nd not fully tested at present) as well as PPP connections.
This will be available with the next release of OGRE.

Workaround

• Try to use another PCIe slot on the mainboard