glifchits / drivefit

reads OBD2 data from a compatible reader and logs it to CSV

python-OBD

A python module for handling realtime sensor data from OBD-II vehicle ports. Works with ELM327 OBD-II adapters, and is fit for the Raspberry Pi.

Installation

$ pip install obd

Basic Usage

import obd

connection = obd.OBD() # auto-connects to USB or RF port

cmd = obd.commands.RPM # select an OBD command (sensor)

response = connection.query(cmd) # send the command, and parse the response

print(response.value)
print(response.unit)

Documentation

Available at python-obd.readthedocs.org

Commands

Here are a handful of the supported commands (sensors). For a full list, see the docs

note: support for these commands will vary from car to car

• Calculated Engine Load
• Engine Coolant Temperature
• Fuel Pressure
• Intake Manifold Pressure
• Engine RPM
• Vehicle Speed
• Timing Advance
• Intake Air Temp
• Air Flow Rate (MAF)
• Throttle Position
• Engine Run Time
• Fuel Level Input
• Number of warm-ups since codes cleared
• Barometric Pressure
• Ambient air temperature
• Commanded throttle actuator
• Time run with MIL on
• Time since trouble codes cleared
• Hybrid battery pack remaining life
• Engine fuel rate

License

GNU GPL v2

This library is forked from:

• https://github.com/peterh/pyobd
• https://github.com/Pbartek/pyobd-pi

Enjoy and drive safe!