god-father-xuez / masternode_script

This script will install and configure your XUEZ Coin masternodes.

VPS Masternode with TOR ready setup script.

To run the script simply type the following commands into your VPS terminal.

Installation: wget https://github.com/johnlito123/masternode_script/releases/download/#/XuezUpdate.sh && chmod 755 XuezUpdate.sh && sudo ./XuezUpdate.sh

Masternode Basic Requierments

• 1,000 XUEZ

• Main Computer with XUEZ wallet installed

• Masternode Server

• Unique IP address for EACH masternode

Local Wallet Procedure

Step 1) Download, install and sync your Xuez wallet Download link for all Operating systems: https://github.com/XUEZ/XUEZ/releases

Step 2) Using your main wallet, enter the debug console and type the following command:

• masternode genkey

• Please save this on a Notepad

Step 3) Using your main wallet, enter the debug console and type the following command:

• getaccountaddress INSERT_MASTERNODE_NAME

• Please save this on a Notepad

Step 4) Send 1,000 XUEZ to Step 3 address.

Step 5) Using your main wallet, wait for 15 confirmations, and then enter the debug console and type the following command:

• masternode outputs
• Please save this on a Notepad 

Step 6) Locate your masternode.conf and add the following line:

<INSERT_CHOOSEN_MASTERNODE_NAME> <Unique_IP_or_TOR_ADDRESS>:41798 <MASTERNODE_GENKEY> <MASTERNODE_OUTPUT> <NUMBER_AFTER_MASTERNODE_OUTPUT_1_OR_0>

Note: Substitute it with your own values and without the “<>”s

Example: MN1 31.11.135.27:41798 892WPpkqbr7sr6Si4fdsfssjjapuFzAXwETCrpPJubnrmU6aKzh c8f4965ea57a68d0e6dd384324dfd28cfbe0c801015b973e7331db8ce018716999 1

Run and follow the instructions on the script

TOR Activation

Step 1 - Find the node onion address

Command: ./xuez-cli getnetworkinfo

Look for the TOR address at the end of the output (EG. aedFAWE235AGa2.onion)

Step 2 - Edit your LOCAL (Not VPS) masternode.conf by replacing the old IP address with the new .onion TOR address.

Step 3 - Restart the local wallet Windows, Max and Linux GUI; Close and open your wallet

Linux CLI:

Command: ./xuez-cli stop then: ./xuezd -reindex

Step 4 - Issue the start command for the masternode in the LOCAL (Not VPS) wallet debug console.

For example: startmasternode alias 0 MN01

Note: Where by MN01 is your chosen Masternode name Wait a few minutes for the MN ip address to change to the onion address in the masternode tab.

Step 5 - Restart the wallet on the VPS with the following commands.

Command: ./xuez-cli stop

then: ./xuezd -reindex

Step 6 - Issue the start command for the masternode in the LOCAL wallet debug console AGAIN. ie follow step 4 again.

Step 7 - Wait up to 30 minutes for the MN timer to change from 00:00 to a postive time in the masternode tab.

Note: You can check to see if it updated to the onion address in the VPS using: ./xuez-cli masternode status