This repository is part of the open-source project: EVGE - Electric Vehicle Global Equipment:

EVSE - Electric Vehicle Supply Equipment
EVCE - Electric Vehicle Charge Equipment
EVBE - Electric Vehicle Battery Equipment
- BMS (https://github.com/EnnoidMe/ENNOID-BMS)
- Scalable Battery Pack
EVPE - Electric Vehicle Powertrain Equipment
- Motor Driver (https://github.com/EnnoidMe/VESC-controller)
- Gate driver (This repository)
- Scalable Three-Phase Electric Motor

ENNOID - Dual Gate Driver

The "Dual Gate Driver" is a sub-component of the EVPE project and can be directly connected to this control board:

https://github.com/paltatech/VESC-controller

The driver is pin compatible with several power modules such as the ones listed below:

V0.1 (untested & archived):

V0.1 is based upon the design from wolfspeed two-channel gate driver for 1200V SiC MOSFET power modules

https://www.wolfspeed.com/cgd15hb62p1

Feature:

Dual gate driver
2W Isolated power supply / gate
Direct mount low inductance design
Short circuit protection
Under voltage protection

Changes from the original wolfspeed design:

Added Voltage sense circuit (Experimental)
98 x 60 mm 2 layer PCB made with Kicad
Current sensor connector
Temperature sensor circuit & connector
Minimum SMD 0805 components size for easy handsoldering
2x8 (16) pins headers for easy connection with VESC board

V0.2:

V0.2 is based upon the design from tiduc70a.pdf.

http://www.ti.com/lit/ug/tiduc70a/tiduc70a.pdf

Changes from V0.1 include:

BJT based powerstage instead of mosfet IC IXD-609
Adjustable soft turnoff feature
SMD gate resistor instead of MELF
Active clamping / Over voltage protection
Shoot trough EMI protection on PWM input

jagdeepsingh02 / ennoid-dual-gate-driver Goto Github PK