jarabt / building-an-arduino-on-a-breadboard

Arduino project: components in detail

Building-an-Arduino-on-a-Breadboard

Basic Parts for wiring up Arduino (5V):

1pc 	Breadboard
	Around 800 points which is double size of the one from Arduino Starter Kit  
    	http://www.ezk.cz/nepajiva_kontaktni_pole.htm
xpcs 	22 AWG wire
	American wire gauge (AWG), standardized wire gauge system for the diameters of round,
	solid, nonferrous, electrically conducting wire. This one should be with diameter 0.644mm.
	Arduino Starter Kit
1pc	7805 Voltage regulator
	A mechanism to provide a consistent 5V Supply.
	http://www.ezk.cz/stabilizatory_reference.htm
2pcs	LEDs
	Arduino Starter Kit
2pcs	220 Ohm resistors
	Arduino Starter Kit
1pc	10k Ohm resistor
	Arduino Starter Kit
2pc	10 uF capacitors (not from ASK - there are only 100 uF)
	http://www.ezk.cz/kondenzatory_elektrolyticke_radialni_elrs.htm
1pc	16 MHz clock crystal
	http://www.ezk.cz/krystaly.htm
2pcs	22 pF capacitors
	http://www.ezk.cz/kondenzatory_keramicke.htm
1pc	small momentary normally open ("off") button, i.e. Omron type B3F
	Arduino Starter Kit 

USB to Serial Communication Board https://www.sparkfun.com/products/12731 (If you plan to use it and have not yet soldered headers to the breakout board, now would be a good time.)

Bootloading your Atmega Chips