jeremycole / allsensors_dlhr Goto Github PK

We use DLHR-L01D-E1BD-C-NAV8 with nRF52 MCU (MDBT42Q Module)

When we compile NAV8 library over Arduino IDE based on Adafruit Feather nRF52 board we got delay error because that one library for AVR based Arduino board so we change over Library.CPP file and remove delay of AVR and Add manual delay function delayMicroseconds(100);

Now able to compile code and upload it but we get continue nan for both parameters (Pressure and Temperature).

Then for status verification, we read status and we got 100 value over gagepressure.status

(gagePressure.status value is continue 100 )

Can you suggest to me what is wrong or any setting issue with sensor ??

I am able to scane sensor I2C address successfully 0x29 over serial but when we read parameter we got nan nan nan.....

Thank you.
AB.

Hi,
My name is Vu. i just bought allsensor_DLC-L20G-U2, DLC-L01G-U2 from digikey, i cannot find any library for this, however DLHR have the same structure with DLC. Can i use this library for my sensor, and how can i config or get the data from that
This is data sheet of DLC series https://www.allsensors.com/datasheets/DS-0365_Rev_A.PDF