keycapsss / 2-milk-build-guide

Build guide for the 2% Milk 2-Key Macropad

Build guide for the 2% Milk 2-Key Macropad

• Hardware Availability: Open Source, Keycapsss
• QMK firmware page

1: Solder the Mill-Max Hotswap Sockets

2: (Optional) Solder the WS2812B RGB Led

3: Solder the header pins for the Pro Micro

It's not necessary to solder all pins.
The marked pins are used by the milk pcb.

Pcb bottom view.

4: Install the switches to the 3d printed case

5: Install the Pro Micro to the back of the 3d printed case

Build Firmware

Make example for this keyboard (after setting up your build environment):

make spaceman/2_milk:default

or

qmk compile -kb spaceman/2_milk -km default

Then use QMK Toolbox to flash the firmware on the Pro Micro.
Before connect RST and GND pins with a paper clip or tweezers, to bring the Pro Micro into the Bootloader Mode.

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Credits

• Case made by Soft
• PCB made by PyroL