matsstaff / stc1000pid Goto Github PK

Add ability to update Pd setting in autotune firmware.

Need to establish 'best' tradeoff of the ratio of P, I and D settings. How slow/fast process should I assume?
This probably needs some empirical data...

Change 'soft off' to run mode 'off'.
Set run mode after profile done.

Dear Mats,
first of all, my apologies, if I ask a question in an inactive branch. Secondly, thank you so much for your great tweaking of the STC-1000!
I have already successfully used the OVBSC version and brewed two great batches of beer. Cheers!

I was now curious about the PID version and I think I successfully completed the autotune.
However, I now wonder how do I access the values (cP,cI,cd) stored in the EEPROM. When I hit the "on" button or up- and down button I do get values (0, 112, 258 in my case). Are these the right ones? If so, what is the correct order, which is which?
Thanks again, Best, Taim

Should I filter output as well? In case of Pd > 1, it could be beneficial. Or is D filtering enough?

Needs a hysteresis and would depend on Pb2 setting?

Good day,
Is there any way to develop this controller to use DHT sensor for reading temperature and humidity by DHT sensor?
And one more thing, if it is possible to control temperature and humidity instead of cooling, and if there is a way to add extra outputs by SSR?