Stops running after reprogramming about openeew-sensor

[johnwalicki]

Hi Neil - This ticket is potentially opened in the wrong repo. OpenEEW firmware is discussed over in the
https://github.com/openeew/openeew-firmware
repository.

I suggest that you try to flash the board again. Its not booting at all. Grab the binaries from here:
https://github.com/openeew/openeew-firmware/releases/download/1.5.0/openeew-firmware150.zip

[neilh10]

Hi John. I put it here because it seems like it is at base board support level or at an (embedded?) flash.
I flashed it three times, (edited above) with openeew-firmware151 and it works until it power cycles.
The other two boards are good with flashing openeew-firmware151.

So are you suggesting regressing back to openeew-firmware150 to see if that makes a difference?

[johnwalicki]

I wasn't advocating for v1.5.0 vs v1.5.1 binaries. It was just the easiest link I could send you.
Would be easier to watch the serial terminal and diagnose what's happening to your boards.
If you think you can share them via a WebEx, I'll send you a link.

[neilh10]

I have it setup connected through a powered USB Hub to a riPi4/Ubuntu - so could try WebEx.

[neilh10]

I was able to reprogram it with openeew-firmware151, with John watching/cell, add it to the network and it booted.
It then was able to access WiFi, and also 1G network, but not my 8 Port 10/100Mbit router.
I rebooted a couple of times, and it came up every time. John reset it remotely a couple of times and it came up every time.
Closing - as this device A8032A4DD650 is now reprogrammed OK.