petrasvestartas / opennest

Hi there, I'm Petras Vestartas 👋

opennest's Issues

NFP calculations

Hi @petrasvestartas the project looks really nice and clean!

I was wondering if you had solved the issue you were facing before with regard the additional holes in the NFP when using Minkoski from clipper?

Unable to load Minkowski.dll

Hi @petrasvestartas,
Thanks a lot for opening OpenNest up to github. I'm just learning but this is super interesting stuff! I was trying to see if I could implement this as a rhino command instead of a grasshopper component and came across this error when trying to run the command which I see you were working on.
I also found you wondering about the same issue I think here: fel88/DeepNestPort#3 (comment) You mention there that there's a Rhino option that does not allow to run unsafe code. Where is this option? And do you know more about this option? What is "Safe" or "Unsafe code" according to Rhino?

Is there by the way a reason you didn't release it as a plugin for running from the command line?

Thanks a lot!

Code missing

Hello petras,
i would like to make some variations of the grasshopper node.
there are some parts of youre code missing. could you upload them ?
like openNestSolver.cs, openNestCOmponent.cs or the deepnestlib. i could find the deepnestlib somewhere else, but dont know if you made some changes or not.
that would be really helpfull 👍
thnx for your great work

Different Spacing for pieces and sheet margin?

Hi. I do use a router tool with diameter of 10mm to cut the nested shapes into MDF materials but I do need that the spacing all around the sheet to be only 5mm. It is possible to add another input and move the spacing for the edges of the sheet to that input. So, basically I do need two spacing. One for tool and another one for the edge of the sheet. Best regards.

Parameter Chunk is Missing Errors

Found that any update to any available version on food4 rhino greater than 1.3 version causes errors when opening grasshopper.

singled it down to Open Nest. Any thoughts?