plarsson / com.globalcache Goto Github PK

You can write more Itach Contact Closure (Relay) controllers? Thanks

Hi, can you please me help with string for command? I want sent command as in picture.

I try any combinations:

        { "name": "on0", "value": "*Z01ON" },
        { "name": "on1", "value": "*Z01ON\u000D\u000A" },
        { "name": "on2", "value": "\u002A*Z01ON\u000D" },
        { "name": "on3", "value": "\u002A\u002AZ01ON\u000D" },
        { "name": "on4", "value": "\u002A\u002AZ01ON" },
        { "name": "on5", "value": "\u002A\u002A\u005A\u0030\u0031\u004F\u004E" },
        { "name": "on6", "value": "\u002A\u002A\u005A\u0030\u0031\u004F\u004E\u000D" },
        { "name": "on7", "value": "*Z01ON0D" },

Thx

David

Hi I'm trying to figure out how to send a command to my Marantz receiver by IP2SL.

When I use the iTest application it works with these settings:
ip: 192.168.1.31
Serial 1 (4999)
Command: @pwr:1

Settings from the IP2SL gui/ Serial Parameters
Multiple Ports: Enabled
Baud Rate: 9600
Flow Control: None
Stop Bits: 1
Parity: None
Data Bits: 8

this is the configuration in Homey. It doesn't matter which command I send, all I get is a "CLIENT IS NOT DEFINED" message.
My gues is that the app is connecting to port 4998. Please help,

{
"ir": {
"devices": []
},
"serial": {
"baudrate": "9600",
"flowcontrol": "None",
"parity": "None",
"cmds": [
{
"name": "PowerOn",
"value": "\uPWR:1\u000D"
}
]
}
}

Hi Peter,
I can't paste the Global Cache code on the Homey app interface.
Refer to the figure below.

Please help,
Many Thanks.

Hi @plarsson , I just installed your appstore release version of the app but something strange is going on.
I can add the device in the devices tab and appears in the zone I installed it in but when I want to use the device in a flow it is not listed in the flow editor.
Any idea what's wrong?

When sending the relay open or close commands and filling in a number in the "duration in miliseconds" box nothing happens op the ITACH IP2CC. while Homey is not giving an error.

I suspect that the IP2CC network stack is also crashing since the module IP stack is resetting and comming up with diffrent DHCP IP address. I have set the Itach to use a stratic address for now.

First of all, thank you for a great app! itach is a little gem in combination with Homey.

Unfortunately, SDK 2 apps are not supported by new HP2003...

Is there any chance that you have plans on updating your useful app on occasion? Would be much appreciated