Firmware compile error about repetier-firmware

[Kalus1]

I think I tried to mess with too much on the initial compile. I just started from the original and changed the minimum required settings and it compiled and uploaded ok. Will let you know how I go :)

[repetier]

Hi,

I can compile without error, so I assume you made a mistake in the Configuration.h. I guess you changed

#define MIN_EXTRUDER_TEMP 0

into something with wrong syntax. For a higher temp use

#define MIN_EXTRUDER_TEMP 160

If this is not the case, copy your config and try compiling with the original, just to see if you introduced the error or you Arduino-IDE causes incompatibilities. But I tested with version 023 on Windows, so I guess it's not the case.

[Kalus1]

Exactly... I was obviously going through it all too quickly and made a typo on that line. I have compiled and uploaded, steppers are working as they should, just have to sort out the thermistors now... heated bed is showing current temp of 325'C. I've learnt my lesson, and will make progressive changes and check as I go, rather than changing everything at once.

I'm very impressed with it all so far, you seem to going a lot further with improvements than anyone else. Good work and thank you very much!

Cheers
Kyne