RAMPS 1.4 heated bed not turning off about repetier-firmware

[repetier]

That the heated bed doesn't turn off is normal when the temperature reading is lower then target temperature. So the question is what your error in the configuration.h file is. Without the config I can't say what is wrong, but the most common error is changing this:

/** Index of analog sensor to read temperature of heated bed.
THIS IS NOT A PIN NUMBER - IT'S A REFERENCE TO A TABLE WITH PIN NUMBERS!!!
Look at ANALOG_INPUT_CHANNELS for the position
or to add the Arduino pin id there. */
#define HEATED_BED_SENSOR_PIN 1

Ofter users set this to a pin number which is wrong.

For the fan try using
#define SIMULATE_FAN_PWM

[johnoly99]

I read the comment above that HEATED_BED_SENSOR_PIN 1 and did not change that. I definately wanted to, many many times! Lol. Ok, I'll look at the SIMULATE for the fan, but I didn't change that either way? So, any tips how to confirm I have the right pins.h setting for my heater input? If it helps, here's a link to my zipped up Firmware

https://docs.google.com/open?id=0B5UPiwyWbj9mT0NpQ0ZQV1Fidm8

[repetier]

Your link doesn't work for me. Get always redirected to the google drive start page. Permissions??? You can send it to [email protected] instead.

[johnoly99]

Will do. And, appreciate all the awesome work