shikyc / taiko-drum-controller-arduino Goto Github PK

作者您好，我參考了您的文檔搭建了使用橋式整流器的電路。使用的板子是arduino leonardo，橋式整流器使用的是DB105(店家DB107缺貨)，電阻使用100k歐姆。
目前遇到的問題是，沒有裝橋式整流器的話，敲擊可以感測到，但是有裝的話就感應不到敲擊。想請問作者有遇到這種狀況嗎？

作者您好，我参考了您的文章，打算使用您分享的PCB电路图也自己制作一个鼓，可以分享一下您的压电传感器型号吗？ 谢谢~

Hello ShikyC,

Thank you so much for developing this. I am very passionate about getting my own taiko setup up and running.

I have my Taiko (an official arcade taiko) connected to my circuit with bridge rectifiers. I am seeing approximately 4V constant voltage out of the output of the rectifiers when I put my multimeter across it, but I do see a change when I strike the drum in the respective locations.

However, whenever I open the serial monitor to see what is happening in DEBUG mode, I am getting basically constant values from the Serial Monitor, 126945 just over and over again. I'm trying to figure out what's going on that would cause this behavior.

If I change one of the sensitivities of one of the sections of the drum, all the values change from 126945 but still they do not react to the pounding of the drum.

Implement the 2-player mode for ESP32/ATmega boards (keyboard emulation). Preferably refactoring and merging all the sketch files (except the ESP32-analog one) into one file for better maintanence capabilities.

The project has changed significantly since the README files were created and some of the documentation is outdated.