simosmcmuffin / flexibms_lite_fw Goto Github PK

If you set the Par. #13 (fw: 0.17c) for the lowest allowed external NTC-temperature of the battery it always triggers "LOW_NTC_TEMP" fault and halts charging.

In my case I set $13=278 (~ 5°C) and from the reading I got values around 290 (NTC-TEMPERATURE PROBE, 10KOHM).
It triggers the fault with no reason: 278<290 .

I have tried different values but the result is always the same.

Trying to connect to FlexiBMS Lite 12S 1.0, I’m not able to issue any commands.

b264@computer:~$ cu -l /dev/ttyACM0 -s 115200
Connected.


Invalid command, type "$?" for command list


Invalid command, type "$?" for command list


Invalid command, type "$?" for command list


Invalid command, type "$?" for command list

Anytime I press any key, it immediately responds with Invalid command, type "$?" for command list without waiting for me to finish typing or even press enter.

Any keypress immediately responds with error. Any key on the keyboard. (except, it seems, Ctrl+Shift+J)

This is using 115200 baud, 8 data bits, 1 stop bit, no parity, XON/XOFF flow control

No combination of newline settings change anything.

Using PuTTY or another application to connect does not help.

It seems that 0.18 tree does not compile:

https://github.com/SimosMCmuffin/FlexiBMS_Lite_FW/tree/0.18

because of this:

SimosMCmuffin/FlexiBMS_Lite_FW/blob/0.18/Src/AuxFunctions.c#L394

also off topic question. Is there a reason why posted .bin(s) are compiled in DEBUG mode ?