smithyat / ultituner

UltiTuner - the Swiss army knife for Ultimaker printers

Hi there 👋

ultituner's Issues

Ultimaker S5 7.1.3 safetotouch + cooldown not compatible

Hi,
I am on 7.1.3 on an Ultimaker S5. The active leveling and reboot command works but I can not adjust safetotouch or cooldown.
Ultimaker might have changed this terminology in 7.1.3?

This is the message print out in terminal.
"Checking printer/firmware compatibility.....done, but not compatible"

Thanks

Reset the state after aborting a print job

When aborting a print job during the pre-print phase (heat up, leveling,...) the printer shows a message dialog with something like "Aborted, do you want to retry?"

When you abort from remote or from the digitalfactory you don't have any chance to start a new print again until someone presses the Abort button on the printer itself.

This new feature will allow you to clear/reset the state, that the printer is ready again to accept new print jobs.

Nozzle temperature during auto-levelling

Hi,

The S5 heats the nozzle up to the printing temperature of the installed filament for the levelling procedure, this means that if you use a coated print bed (say PEI), the nozzle will met little areas of the bed during the levelling procedure.

If the nozzle temperature was reduced to say 150 - 160C for this procedure, then this melting wouldn't occur. I'm trying to find where this temperature instruction is located, I think it's probably in the prePrintProcedure.py file.

Anyway, just an idea for the next version of UltiTuner.

Thanks

John

Firmware 8.2.1 compatibility

I have an S5 with firmware 8.2.1. Ultituner returns a "firmware non compatible" message. Any chance it will be updated to support this firmware?

Printer Authentication

this is a question and not an error message. i am trying to make the same as you but only for the clearbed command in python for a project in my intership. I'm trying to make an ssh connection but I don't know how you did that without using the printer Authentication. because I don't see in the code that you use
credential to connect.

sorry for my bad English.

Ultimaker S5 -7.1.3 Webcam

Hi,
I am on 7.1.3 on an Ultimaker S5. The adding another webcam is not working for me. Perhaps is the firmware I currently have,

This is the message print out in terminal.
"Checking printer/firmware compatibility.....done, but not compatible"

Thanks