teslore / cr-10-bed-level-helper

3 different scripts that will help you level the bed of your Creality Cr-10 if you don't have an auto bed leveling addon.

!!The scripts are printer specific so make sure you only use the one for yours!!

The names have a number in the beginning so that you know exactly which script to run since sometimes the screen(Cr-10) doesnt show all letters

• 1.Level.CR-10 is for the 300x300 printer
• 2.Level.CR-10-S4 is for the 400x400 pinter
• 3.Level.CR-10-S5 is for the 500x500 printer

WHAT IT DOES:

It will move to each corner and zero the z axis on it for 30 seconds. When 10 seconds are left, it will beep to let you know. Before returning to the home position it moves to the center to verify the leveling there.

HOW TO USE IT:

1. Choose the correct gcode script for your printer.
2. Upload it to your printers SD card and run the program.
3. Wait for the printer to finish homing the Z axis and then level the bed with your prefered method.

Recomendations:

Lower your bed before you run the script so that you extruder doesnt crash into the bed and damage anything.