unipd-dii-etcomp / peec-1d

PEEC-1D

PEEC 1D

This directory contains a PEEC code, based on stick elements, for the solution of full-wave electromagnetic problems. It can be used for research and academic purposes.

Optimized, parallel (OpenMP), fortran90, general versions of this code have been used in, e.g.,

• R. Torchio et al.,"A 3-D PEEC Formulation Based on the Cell Method for Full-Wave Analyses with Conductive, Dielectric, and Magnetic Media," in IEEE Transactions on Magnetics. doi 10.1109/TMAG.2017.2750319
• R. Torchio, "A Volume PEEC Formulation Based on the Cell Method for Electromagnetic Problems From Low to High Frequency," in IEEE Transactions on Antennas and Propagation, vol. 67, no. 12, pp. 7452-7465, Dec. 2019, doi: 10.1109/TAP.2019.2927789
• P. Baumgartner et al., "Multi-Objective Optimization of Yagi-Uda Antenna Applying Enhanced Firefly Algorithm With Adaptive Cost Function," in IEEE Transactions on Magnetics. doi: 10.1109/TMAG.2017.2764319
• T. Bauernfeind et al., "Multi-Objective Synthesis of NFC-Transponder Systems Based on PEEC Method," in IEEE Transactions on Magnetics. doi: 10.1109/TMAG.2017.2771366
• R. Torchio, P. Bettini and P. Alotto, "PEEC-Based Analysis of Complex Fusion Magnets During Fast Voltage Transients With H-Matrix Compression," in IEEE Transactions on Magnetics. doi: 10.1109/TMAG.2017.2651638
• P. Baumgartner et al.,"Synthesis of NFC antenna structure under multi-card condition," in Applied Computational Electromagnetics Society Journal. doi 10.1109/TMAG.2017.2750319

See the above references for more details and consider citing it.

In this code only conductive media modeled by thin 1D (a.k.a "stick") elements are considered.

---

Description

"MAIN_PEEC_1D.m" is the main file you must run to start the code.

All user-settable quantities, e.g. frequency and resistivity, are contained in the block identified by the BEGIN USER SETTINGS / END USER SETTINGS comments.

At the end of the simulation, variable (struct) "sol" contains useful quantities, i.e.:

• sol.I_obj = currents in each stick element of the mesh
• sol.U_obj = electric potentials in each node of the mesh
• sol.Q = electric charges in each node of the mesh
• sol.I_app = currents in each lumped branch
• sol.U_app = electric potentials in each lumped node
• sol.Etot = total (scattered+external) electric field in target points
• sol.Esca = scattered electric field in target points
• sol.Eext = external electric field in target points

---

Available test cases

Several test cases are contained in separate directories under "test_cases". Each directory contains a description.txt file. Set the "test_case_dir" variable in "MAIN_PEEC_1D.m" to the appriapriate directory.

User-defined test cases

Follow the instuctions given in "README.txt" inside the "test_cases" directory.

Contacts

Riccardo Torchio ([email protected])