A 3D printable housing for the Cytron CM4 Maker Board.

Pre-rendered STLs are available on Printables - Cytron CM4 Maker Board.

This design is intended to be fully enclosed for dust ingress protection, and as such may lack adequate thermal dissipation. There's an optional vent pattern that can be turned on if you want to allow for airflow.

• 8x M3x6 screws
• 8x M3 heat-set nuts

Print the two pieces, top and bottom. Then install the M3 heat-set nuts into the holes in the bottom. Screw the board to the the bottom and then the top to the bottom.

This work is licensed under a Creative Commons (4.0 International License) Attribution-ShareAlike