bigtreetech / pi4b-adapter Goto Github PK

Hi folks,
I have installed a CB1 on the adapter and flashed Raspberry Pi Images to SD with WiFI, SSH, and all the common Stuff for first signs of life needed. When I try to connect via SSH, I permanently get Errors, that the device is not found. In my Router I don't get any IP-Addresses. On the board I find only one LED lighting up, but no send/receive signals.
eMMC doesn't work too.

When OS we can use?

File PI4Buper-shell0701.stl has neither it's top nor bottom completely touching the print surface thus resulting in sections printing in mid-air or require supports

Suggestion would be that it is printed with the top on the print surface, however the Bigtreetech Logo is recessed under the top thus result it printing in mid-air or requiring supports so my suggestion would be to raise the logo so that it is flush with the top thus touching the print bed.

If possible, please also provide the CAD file for the shell like the board itself.

PI4B-Adapter with CB1
How to access GPIO pins? If its the same as using a raspberry pi - then how would you flash the CB1 as an MCU? and then use the onboard GPIO pins?

hi
my act and pwr lights doesn't seam to work.
i have plugged the cb1 to the adaptor and flashed the newest official firmware i could find for the cb1 but still no lights
i have also tried searching for a configuration but no luck.
please help i need to know if its on or not

No one of the 3d .step files is able to be open, all of them are reporting errors, I can open the one of CB1, even having an error, but I can not open any one of the Pi4B adapter files

Can you reupload the CAD models? They are 1kb and import as corrupted or missing geometry into my CAD system.

I just got the pi4b and cb1 and bought an inland IR cam for a pi, it gets power but isn't showing up on anything. Does the port not work? I keep seeing some people say it didn't but some say it does now.

Using the hardware combination as mentioned in the issue title, is it even possible to "hardwire" the TFT35 SPI V2.1 display to the GPIO pins of the PI4B-Adapter, which is using a CB1 V2.2?

I'm fairly sure I've got the correct pins wired correctly, however none of the CB1 overlays seem to change anything, and all I get is a white screen. It is also worth nothing that I'm only using the GPIO, and only the 9 out of 10 available pins from the display, eg. not using the "IRQ" pin at the top, as I couldn't figure out where that comes in.
Also I'd like to reiterate that this setup does not have a BTT mainboard of any kind, with the idea being that this could be a slightly more "standalone" solution to running Klipper + KlipperScreen.

After spending hours and hours on researching this, I'm still not any closer to figuring out a solution.