Re-implentation in real world about giga

[Steve-Tod]

1. GIGA focuses on generating grasps from a fixed single view. Although we have done some randomization on the camera view, GIGA has limited generalizability to arbitrary view. So I would suggest first trying aligning your camera view with the one we used in the simulation as accurate as possible and then test the pretrained ckpt.

2. As mentioned above, aligning the camera view should help improve the result. Our real-world depth is also very noisy, I think it should be fine as long as objects are correctly captured.

3. We didn't use any planner. The collision avoidance is actually learned implicitly through data prior. Because in the data generation, a grasp would be labelled as fail if it collides with other objects before getting to the target grasp pose. So our grasp predictor always prioritize the grasps that would not cause any collision.

[mousecpn]

Following your advice, we set the camera pose as the same as in the simulation.

But the quality of the generated grasp is still low.

With the packed checkpoint you provide, I can only realize 20% grasp success rate.

Can you give me some advice what to do next?

[Steve-Tod]

Hi, I think I know the issue. During real-robot experiment of GIGA, we found we were not able to align camera view perfectly, so we additionally trained a model with randomized side view (basically adding noise on the camera view when generating data). The resulting model is more robust to the misalignment of the camera view. I also uploaded those models here (https://utexas.box.com/s/47po84j62g7zgwogpr453sl3ch64vm6q).

Actually we kinda reproduce the GIGA on the real robot about a year ago and these models work fine. Only thing we need to fix is tuning an offset and add that to the predicted grasp, because the predicted grasp is with respect to the root of the gripper, while our real gripper is a bit different from the simulated one. You might also need to go through this.

Please let me know if this helps!

[mousecpn]

Hi, I use your checkpoint but the accuracy is still low.
May I ask what camera are you using? And what configuration did you set (resolution, etc.)

[mousecpn]

I think I found the bug. In the simulation, there is always a 5cm table in the workspace.
In order to generate a collision-free grasp, the model will tend to generate grasps much higher than 5cm. Besides, the grasps below 5.5cm will be filtered.
So I lower the task frame and everything works fine now.

[Steve-Tod]

Sorry I was planning to look into this today. But glad you found the issue and GIGA works out now!